3rd Gen - 2x 9007 LED Ultimate Decoders - fixes flickering, "bulb out", and lights shutting off issues

CAD $55.00
(No reviews yet) Write a Review
in stock
Calculated at Checkout


If your vehicle's daytime running lights operate at a voltage below 8V, then most LED kits either won't even light up at all or they will operate at reduced light output. We have the perfect solutions for this problem which is similar to installing a relay harness. Our new DRL modules allow you to use any LED kit incapable of running at low voltage DRL (min start-up input voltage is 7.5V), giving it full power, so it is always as bright as possible at any voltage between 7.5V and 12V. These modules also provide full anti-flickers and canbus compatibility to all non-canbus LED kits.


Connect one power cable on each module to the vehicle's OEM light power connector. Connect the other power cable on each module to the new LED bulb from an LED kit. Connect the supplied power wire to the battery's + and - and then each of the two ends to one of the DRL modules. When the car's headlights are ON (i.e. supply is 12V+) then the module does not draw any power from the battery. However, as soon as power to the lights drops below 12V, the module starts to supply the LED lights with full battery power, so the LEDs do not go dim but rather operate at the full possible brightness. So, if your DRLs operate at a low voltage (min required voltage on start-up is 7.5V), then the modules will always supply full power to the lights and they'll work regardless of the minimum voltage required for the led bulbs to light up. Once you turn the car's headlights to ON, the modules will stop drawing power from the battery because it is no longer needed to keep the lights at full brightness.

Package Includes:

  • 2 DRL canbus modules
  • 1 Power cable


  • Minimum Required Voltage for modules to work: 4.1V
  • Battery power is supplied when DRL power drops below 12V
  • Module size: 2.5" (W) x 2.5" (L) x 1" (H)
  • Rated Power: 55W (+/- 10%) 
  • Actual Power: 50.5W (4.2A@12V) with LED kit connected
  • CANBUS Compatible: YES
  • EMC built-in: YES
  • Cable length: 67" (module to module)
  • Cable lenght: 30" (battery to a T-connector where it connects to the module to module cable)
  • Red battery + cable has a built-in replaceable 25A fuse 
  • Everything is plug-n-play for easy installation

 9005 Connection Diagram is below. 9007 will be the same except for the power plug shown in the photo below.


1 year